Update on the Beholder DS1 Camera Stabilizer Manual and DS1 Customer Video
Discover the best value in camera stabilization with a Beholder DS1 Camera Stabilizer for $699.95 or a Beholder MS1 Camera Stabilizer $499.95. Order now and get an extra set of batteries.
Pictured below is a Beholder DS1 Camera Stabilizer with Canon.
The 3rd shipment of Beholder DS1 Camera Stabilizer 14/20 units is accepting pre-orders. This 3rd shipment is planned to be shipped off in late October. The factory plans to increase the production numbers of the DS1. Reserve a Beholder DS1 Camera Stabilizer. When you pre-order the DS1 get an extra set of batteries . Get the best in stabilizer support from OwlDolly, based in Los Angeles, CA.
Customer video from Mixtus featuring a Beholder DS1 Camera Stabilizer with Canon 5D Mark III and sigma 35mm.
The translated manual for the Beholder DS1 Camera Stabilizer will be available for download this week. The mode selection on the DS1 starts with Follow Mode and by pressing in the joystick once will select Lock Mode by pressing again the joystick in will select Follow Mode. By pressing in the joystick in for 2-3 seconds will select Simi-Lock mode where tilt is locked and yaw follows. Only calibrate the DS1 when it needs to be calibrated, remember the gimbal must be perfectly level, the DS1 has to be placed on a flat surface at 90 degrees, and free of vibrations during calibration. Calibration may need to be attempted a few times to achieve desired results. Locate the tilt stage, on the face of the tilt stage is a silver button, gently press the button and wait 10-30 seconds.
-OwlDolly